Commission Implementing Regulation (EU) 2015/388 of 5 March 2015 concerning the classification of certain goods in the Combined Nomenclature

Type Implementing Regulation
Publication 2015-03-10
State In force
Text As published
Department European Commission
Source EUR-Lex
articles 3

This is the act as published. Later amendments are not folded into the text below: each one is a separate act in this repository and an entry in this law's history.

Reform history JSON API
10.3.2015 EN Official Journal of the European Union L 65/9

THE EUROPEAN COMMISSION,

Having regard to the Treaty on the Functioning of the European Union,

Having regard to Council Regulation (EEC) No 2658/87 of 23 July 1987 on the tariff and statistical nomenclature and on the Common Customs Tariff 1, and in particular Article 9(1)(a) thereof,

Whereas:

HAS ADOPTED THIS REGULATION:

Article 1

The goods described in column (1) of the table set out in the Annex shall be classified within the Combined Nomenclature under the CN code indicated in column (2) of that table.

Article 2

Binding tariff information which does not conform to this Regulation may continue to be invoked in accordance with Article 12(6) of Regulation (EEC) No 2913/92 for a period of three months from the date of entry into force of this Regulation.

Article 3

This Regulation shall enter into force on the twentieth day following that of its publication in the Official Journal of the European Union.

This Regulation shall be binding in its entirety and directly applicable in all Member States.

Done at Brussels, 5 March 2015.

For the Commission,

On behalf of the President,

Heinz ZOUREK

Director-General for Taxation and Customs Union

2

Council Regulation (EEC) No 2913/92 of 12 October 1992 establishing the Community Customs Code (OJ L 302, 19.10.1992, p. 1).

ANNEX

Description of the goods Classification (CN-code) Reasons
(1) (2) (3)
A plastic sheet with dimensions of 62 cm × 52 cm × 150 μm containing 24 antennae. Each antenna is constituted of copper wires in the form of windings of a planar rectangular shape and is connected with two interface pads. The antennae are presented in an array of 8 × 3 and are glued alongside each other on the plastic sheet. The plastic sheet does not contain electronic chips. The antennae are presented to be used as parts of smart cards. See image3 8504 50 95 Classification is determined by general rules 1 and 6 for the interpretation of the Combined Nomenclature, note 2(a) to Section XVI and by the wording of CN codes 8504 , 8504 50 and 8504 50 95 . As the antennae are constituted only of windings acting as inductors, they fall in heading 8504 as inductors. Consequently, classification under heading 8548 as parts not specified or included elsewhere in Chapter 85 is excluded. The article is therefore to be classified under CN code 8504 50 95 as other inductors.

Image omitted; see official source

3

The image is purely for information.

Reading this document does not replace reading the official text published in the Official Journal of the European Union. We assume no responsibility for any inaccuracies arising from the conversion of the original to this format.

This text is published under EUR-Lex's own terms of reuse, not a Legalize or public-domain licence. EUR-Lex
Creative Commons Attribution 4.0 International (CC BY 4.0)
© European Union, https://eur-lex.europa.eu — Source: EUR-Lex (Publications Office of the European Union). Reused under the Creative Commons Attribution 4.0 International (CC BY 4.0) licence. Only EU legislation published in the printed Official Journal of the European Union is deemed authentic; consolidated texts are reproduced here for documentation purposes and have been reformatted to Markdown.