Commission Implementing Regulation (EU) 2025/1952 of 29 September 2025 on measures to prevent the establishment and the spread within the Union territory of Anoplophora glabripennis (Motschulsky) and for the eradication and containment of that pest within certain demarcated areas and repealing Implementing Decision (EU) 2015/893

For column 13: Provide the risk factors in different rows, using as many rows as necessary. For each risk factor indicate the risk level and corresponding relative risk and proportion of host population.

For column B: Indicate the details of the survey, depending on the specific legal requirements for each pest. Indicate with N/A when the information of certain column is not applicable. The information to be provided in these columns is related to the information included in the column 10 ‘Detection methods’.

For column 18: Indicate the number of trapping sites in case this number differs from the number of traps (column 17) (e.g. the same trap is used in different places).

For column 21: Indicate the number of samples found positive, negative or undetermined. ‘Undetermined’ are those analysed samples for which no result was obtained due to different factors (e.g. below detection level, unprocessed sample-not identified, old).

For column 22: Indicate the outbreak notifications of the year when the survey took place. The outbreak notification number does not need to be included when the competent authority has decided that the finding is one of the cases referred to in Article 14(2), Article 15(2) or Article 16 of Regulation (EU) 2016/2031. In this case, indicate the reason for not providing this information in column 25 (‘Comments’).

For column 23: Indicate the sensitivity of the survey, as defined in International Standard for Phytosanitary Measures (ISPM) 31. This value of the achieved confidence level of pest freedom is calculated based on the examinations (and/or samples) performed given the method sensitivity and the design prevalence.

For column 24: Indicate the design prevalence based on a pre-survey estimate of the likely actual prevalence of the pest in the field. The design prevalence is set as a goal of the survey and corresponds to the compromise the risk managers are making between the risk of having the pest and the resources available for the survey. Typically, for a detection survey a value of 1 % is set.

[^ntr1-L_202501952EN.001201-E0001]: Commission Implementing Regulation (EU) 2019/1715 of 30 September 2019 laying down rules for the functioning of the information management system for official controls and its system components (the IMSOC Regulation) (OJ L 261, 14.10.2019, p. 37, ELI: http://data.europa.eu/eli/reg_impl/2019/1715/oj).

ELI: http://data.europa.eu/eli/reg_impl/2025/1952/oj

ISSN 1977-0677 (electronic edition)